Thumb nail

How to Setup an Ad Hoc Wireless Network with Windows Built-in Utility (Windows XP)

The Adhoc network, also called peer-to-peer mode, allows nodes to communicate directly (point-to-point) without the need for an AP, as in the following Figure. There is no fixed infrastructure. Nodes need to be in range with each other in order to communicate.

An Ad Hoc WiFi network should at least consist of 2 clients. In this tutorial, we also take just two computers for instance: computer A and computer B.

Part 1: Create an Ad Hoc network profile on computer A

Step 1

Go to Control Panel -> Network Connections and find Wireless Network Connection. Right-click Wireless Network Connection and select Properties.

Step 2

On the Wireless Networks tab, click Add button.

Step 3

On the Association tab of the Wireless network properties window, please type a phrase for Network Name [SSID]. In our scenario, we take adhoctest for example. Then go to the bottom and tick This is a computer-to-computer [ad hoc] network; wireless access points are not used. Then click OK.

Step 4

After Step 3, there should be a profile named adhoctest in Preferred Networks. Click OK to save all the settings.

Part 2: Manually configure an IP address on computer A

Step 5

Right-click Wireless Network Connection and select Properties.

Step 6

On the General tab, please double-click Internet Protocol (TCP/IP).

Step 7

Tick Use the following IP address and input the IP address and Subnet mask. Then click OK.

Step 8

Click OK on Wireless Network Connection Properties window.

Part 3: Scan for Ad Hoc network on computer B

Step 9

Right-click Wireless Network Connection, select View available wireless networks.

Step 10

Find adhoctest(which is set up on computer A) network in the scan window. Then double click it and click connect Anyway?

Part 4: Manually configure an IP address on computer B

The steps are the same as those which were done on computer A (Step 5 to Step 8). The point is that we need to assign a different IP address for computer B, and it must be in the same subnet as computer A. In our scenario, we can take

Here until, all the basic settings for building an Ad Hoc network have been finished. If we open the network scan window again, we can see the adhoctest network says Connected

Note: Youtube link for ad-hoc network

For more computer network work Click Here